Vertical Surface Solutions - Wall Spray



Wall Spray Benefits



SureCrete formulated Wall Spray as a lightweight, sprayable, co-polymer based coating for increasing the flexural strength, fire rating, and “R” value of exterior surfaces. Typical applications include: ICF, SIP, EIFS, Concrete Block, Concrete Tilt Up, EPS Architectural Foam, Brick Resurfacing, Mag Board, and Cement Board. In each application, attention is given to the functionality of the surface performance including; moisture migration, flame spread, adhesion, and impact resistance.

The technology behind Wall Spray was created by SureCrete in1999 and was first used in freeze-thaw climates as a commercial grade floor bonding and coating system. With over 100+ million sq. ft. applied in North America alone, SureCrete took this proprietary formula, and created a superior vertical cementitious coating unlike any other in the industry.


    Leed Attributes
  • Zero VOC
  • 35% Post Consumer Recycled Content
  • Reduction of Raw Materials Used
    Application Benefits
  • Increase of Flexural Strength to EPS Foam
  • Thin Build, Lightweight Installation
  • Sprayable System Reduces Labor & Timelines





Wall Spray Testing Data



Wall Spray is the preferred environmentally friendly “GREEN” exterior coating. Wall Spray delivers zero VOC and a 35% post consumer recycle content. When combined with the speed of installation and the reduction of 50% of the labor (as compared to traditional stucco applications). The coating at 1/8 inch will provide a “Class A” fire rating on Mag Board, Cement Board and a “Class B” fire rating on OSB with regards to the E-84 Flame spread test. All ratings are acceptable under “Section 803” of the International Building Code.








    COMPRESSIVE STRENGTH: ASTM C-109
  • 14 day 2,330 PSI
  • 28 day 2,870 PSI
    WIND DRIVEN RAIN TEST
  • Passes ( Wall Spray w/ Elasto-Shield passes after 70 cycles)
    FLEXURAL STRENGTH: ASTM C-348-08
  • 14 Day 720 PSI
  • 28 Day 950 PSI
    HUMIDITY CYCLE TEST
  • 60F/75% RH - 8 hours
  • Ramp to 120F/50% RH - over 4 hours
  • 120F/50% RH - 8 hours
  • Ramp to 60F/75% RH - over 4 hours

    TENSILE STRENGTH: ASTM C-190-85
  • 03 day 110 PSI
  • 14 day 140 PSI
  • 28 day 140 PSI
    FREEZE THAW: ASTM C 67
  • 50 Cycles (Passes)
    WATER PERMABILITY: ASTM D2247
  • No Blistering or Cracking
    FIRE TESTING: E-84(Testing on OSB)
  • Class "B" Rating @ 1/8" Thick


For additional tips and tricks on repairing or restoring verticle surfaces, you can go to www.SureCrete.TV, or SureCrete offers the ability to attend specialized classes for vertical coatings. If you are a concrete contractor, and have the desire to make vertical coatings a business, SureCrete offers certification courses which are 3 and 5 day courses. You can see the schedule for these events at www.SureCreteDesign.com.